The fix was to jack the settled area up, scoop out the bad soil, pour a new footing directly on bedrock and let the house back down. Had the bedrock been sloping, rotohammered steel rebar dowels would have been embedded into the rock and extended into the new footing to keep it from sliding.
Sheetrock cracking is caused by structural movement of some sort. If it’s not vertical settlement, then it almost has to be lateral (sideways) movement.
I recall a project with severe plaster cracking on all four exterior walls. It was an old schoolhouse converted into a residence. The foundation was sound, the floors level. Inspection of the roof framing told a different story, however.
The roof was hip style, fairly steep. Rafters bore on the exterior walls and extended upward, terminating at the ridge or a hip, depending on their location. There was a serious problem: there were no collar ties or ceiling joists; nor were there any ridge beams or hip beams. In short, there was nothing to take the outward thrust of the rafters, except the exterior walls. Over the years, all four exterior walls had bowed outward — nearly a foot in the middle of the long walls. It was a miracle that this place did not implode in one of our snowy, Northwest winters.
The fix was to jack the roof system up, and using come-alongs, winch the exterior walls back together as best we could. Then new hip and ridge beams were installed, their bearing extended all the way down through the structure to existing or new footings below. It was a messy, expensive job, but the insurance company paying the bills determined it was more cost-effective than a complete roof system replacement.
In summary, wherever you’ve got significant drywall cracking, you’ve got structural movement. The trick is determining the cause and properly fixing it. Simply replacing or patching the drywall is like putting a Band-Aid over a broken bone — it won’t work. To complicate matters, a small amount of cracking may be due to wood shrinkage — a common phenomenon, especially in newer homes. So, if in doubt, don’t be afraid to get a second opinion. The wrong “fix,” in the long run, will cost far more than a few hours of an expert’s time.
Tim K. Garrison P.E. of ConstructionCalc.com has authored books and short courses and lectures on topics relevant to builders. Got a technical or management issue? E-mail buildersengineer@constructioncalc.com. Tim reads every one.
This column cannot be reprinted without permission from the author.
The views expressed in this article represent the personal views, statements and opinions of the author and do not necessarily represent the views, statements, opinions or policies of the National Association of Home Builders. NAHB does not necessarily endorse any of the views expressed by the author and NAHB is not responsible for any direct or indirect consequences arising out of the views expressed in this article.
[ Go to Top ]